AGRI-COVER Command-10 Instrukcja Instalacji Pobierz pdf (Strona 20)

STEP 18

Run heavy gauge wire from remote control box to electric motor

terminals. Prepare wire ends for motor terminals with heat shrink tubes,

5/16” ring terminals, and rubber boots. Attach BLACK wire to terminal 1

on motor. Attach RED wire to terminal 2. Always hold base nut while

tightening top nut. At Battery, rst attach RED wire to (+) positive post.

Then attach BLACK wire to (-) negative post. Check power by activating

switch to open position and closed position. When done, make sure all

connections are secure and all wires are clear of sharp edges.

Figure 18

Note: Use dielectric grease

(packet included) at all

ellectrical connections.

DUAL POLE CONNECTOR

(USED IN SOME APPLICATIONS)

(M1)

(M2)

HEAVY GAGE WIRE

1 2 ... 15 16 17 18 19 20 21 22 23 24

Brak uwag

AGRI-COVER Command-10 Instrukcja Instalacji Strona 20